Search our site:
 
HH Roberts Machinery Ltd
Questions ?
Call us at 905-624-5536

TW-40 and 50-VF Bed Type Milling Machines

59" x 13"  or 59" x 18" table.

7 1/2 to 15 Hp vector drive spindle. The head is the same as those used on our machining centres

This model is also available with a 40" X axis travel on the TW-40-MVF.

These are both available with a quill type head and 7 1/2 to 15 Hp drive as shown on the TW-32-QVF

Cat-V 40, BT-40 or NMTBA 40 spindle

Built in digital readout with easy upgrade path to CNC because each axis already has CNC class servo feeds installed.

ballscrews on all axes

coolant system with chip pan and side splash guards

worklight

automatic timed lube system

hardened and ground table top and slideways with Turcite counterslides.
6000 RPM. Your choice of back geared or direct drive heads.
Topwell TW-40-QVF bed type milling machine with 40 x 20 x 20 travels
TW-40-QVF
Now available with 11 1/2 or 15 Hp spindle drives on the quill head models.

Field upgrades are available for customers with machines and heads.
Topwell TW50-MV bed type milling machine with 50 x 20 x 20 travels
TW-50-MVF
up to 12,000 rpm

To the right is the electronics cabinet of the VF series. The amplifiers for the X, Y and Z feeds ( Z axis is the ~20" feed on the column )  This is the same series amplifier and servo motors that we have used for years on the Anilam controlled machines that we build.

The top left corner of the panel is empty for future installation of a CNC,  Only a few minor components in this cabinet and changing the pendant for a CNC operator's control panel are required for an upgrade.  The servo motors and amplifiers, spindle control, ballscrews, Turcite slideways, way covers etc are all already on the VF machines.
the cnc ready electronics cabinet of the Topwell VF milling machines
The operator control panel of the Topwell VF series of mills
 To the left is the control pendant for the VF series. The current models come with the Anilam 1000 LCD graphical digital readout as standard equipment.

Controls on the Panel:
At the top left is the spindle speed display. Under the display is the speed setting knob and the forward - stop - reverse switch.

In the middle and are under the white safety bar making them a bit hard to see are the joysticks for axis selection  

Just below the joysticks are the geared knobs for sensitive feed rate setting. Feed rates are displayed on the digital readout.  On the knee mills X and Y have the feed knobs and the vertical knee lift just had the joystick for rapid positioning. On the bed mill versios all 3 axes have feed knobs.
Below the feed knobs are the yellow buttons for the rapid traverse for each axis. 

The lower switches are for the worklight and coolant on the left and an
E-stop on the right.